1 files changed, 93 insertions, 0 deletions
diff --git a/boards/dk-tm4c129x/blinky/blinky.c b/boards/dk-tm4c129x/blinky/blinky.c
new file mode 100644
index 0000000..d9c0873
--- /dev/null
+++ b/boards/dk-tm4c129x/blinky/blinky.c
@@ -0,0 +1,93 @@
+//*****************************************************************************
+//
+// blinky.c - Simple example to blink the on-board LED.
+//
+// Copyright (c) 2013-2014 Texas Instruments Incorporated.  All rights reserved.
+// Software License Agreement
+// 
+// Texas Instruments (TI) is supplying this software for use solely and
+// exclusively on TI's microcontroller products. The software is owned by
+// TI and/or its suppliers, and is protected under applicable copyright
+// laws. You may not combine this software with "viral" open-source
+// software in order to form a larger program.
+// 
+// THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS.
+// NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT
+// NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
+// A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY
+// CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
+// DAMAGES, FOR ANY REASON WHATSOEVER.
+// 
+// This is part of revision 2.1.0.12573 of the DK-TM4C129X Firmware Package.
+//
+//*****************************************************************************
+
+#include <stdint.h>
+#include "inc/tm4c129xnczad.h"
+
+//*****************************************************************************
+//
+//! \addtogroup example_list
+//! <h1>Blinky (blinky)</h1>
+//!
+//! A very simple example that blinks the on-board LED.
+//
+//*****************************************************************************
+
+//*****************************************************************************
+//
+// Blink the on-board LED.
+//
+//*****************************************************************************
+int
+main(void)
+{
+    volatile uint32_t ui32Loop;
+
+    //
+    // Enable the GPIO port that is used for the on-board LED.
+    //
+    SYSCTL_RCGCGPIO_R = SYSCTL_RCGCGPIO_R14;
+
+    //
+    // Do a dummy read to insert a few cycles after enabling the peripheral.
+    //
+    ui32Loop = SYSCTL_RCGCGPIO_R;
+
+    //
+    // Enable the GPIO pin for the LED (PQ7).  Set the direction as output, and
+    // enable the GPIO pin for digital function.
+    //
+    GPIO_PORTQ_DIR_R = 0x80;
+    GPIO_PORTQ_DEN_R = 0x80;
+
+    //
+    // Loop forever.
+    //
+    while(1)
+    {
+        //
+        // Turn on the LED.
+        //
+        GPIO_PORTQ_DATA_R |= 0x80;
+
+        //
+        // Delay for a bit.
+        //
+        for(ui32Loop = 0; ui32Loop < 200000; ui32Loop++)
+        {
+        }
+
+        //
+        // Turn off the LED.
+        //
+        GPIO_PORTQ_DATA_R &= ~(0x80);
+
+        //
+        // Delay for a bit.
+        //
+        for(ui32Loop = 0; ui32Loop < 200000; ui32Loop++)
+        {
+        }
+    }
+}