Add more board models

1 files changed, 49 insertions, 0 deletions

diff --git a/boards/ek-lm4f232/boot_demo2/readme.txt b/boards/ek-lm4f232/boot_demo2/readme.txt
new file mode 100644
index 0000000..22d00e7
--- /dev/null
+++ b/boards/ek-lm4f232/boot_demo2/readme.txt
@@ -0,0 +1,49 @@
+Boot Loader Demo 2

+

+An example to demonstrate the use of a flash-based boot loader.  At startup,

+the application will configure the UART, USB and Ethernet peripherals, wait

+for a widget on the screen to be pressed, and then branch to the boot

+loader to await the start of an update.  If using the serial boot loader

+(boot_serial), the UART will always be configured at 115,200 baud and does

+not require the use of auto-bauding.

+

+This application is intended for use with any of the three flash-based boot

+loader flavors (boot_eth, boot_serial or boot_usb) included in the software

+release.  To accommodate the largest of these (boot_usb), the link address

+is set to 0x2800.  If you are using serial or Ethernet boot loader, you

+may change this address to a 1KB boundary higher than the last address

+occupied by the boot loader binary as long as you also rebuild the boot 

+loader itself after modifying its bl_config.h file to set APP_START_ADDRESS

+to the same value.

+

+The boot_demo1 application can be used along with this application to 

+easily demonstrate that the boot loader is actually updating the on-chip

+flash.

+

+Note that the LM4F232 and other Blizzard-class devices also the

+support serial and USB boot loaders in ROM.  To make use of this

+function, link your application to run at address 0x0000 in flash and enter

+the bootloader using either the ROM_UpdateUSB or ROM_UpdateSerial

+functions (defined in rom.h).  This mechanism is used in the

+utils/swupdate.c module when built specifically targeting a suitable

+Blizzard-class device.

+

+-------------------------------------------------------------------------------

+

+Copyright (c) 2008-2014 Texas Instruments Incorporated.  All rights reserved.

+Software License Agreement

+

+Texas Instruments (TI) is supplying this software for use solely and

+exclusively on TI's microcontroller products. The software is owned by

+TI and/or its suppliers, and is protected under applicable copyright

+laws. You may not combine this software with "viral" open-source

+software in order to form a larger program.

+

+THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS.

+NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT

+NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR

+A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY

+CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL

+DAMAGES, FOR ANY REASON WHATSOEVER.

+

+This is part of revision 2.1.0.12573 of the EK-LM4F232 Firmware Package.