From 8e4bff4cab0ddac6060645b0715210484d02ff40 Mon Sep 17 00:00:00 2001 From: Yuval Adam <_@yuv.al> Date: Wed, 30 Aug 2017 08:25:59 +0000 Subject: Initial file dump from open source release --- drivers/usb/image/Kconfig | 28 ++++++++++++++++++++++++++++ 1 file changed, 28 insertions(+) create mode 100644 drivers/usb/image/Kconfig (limited to 'drivers/usb/image/Kconfig') diff --git a/drivers/usb/image/Kconfig b/drivers/usb/image/Kconfig new file mode 100644 index 00000000..320d368c --- /dev/null +++ b/drivers/usb/image/Kconfig @@ -0,0 +1,28 @@ +# +# USB Imaging devices configuration +# +comment "USB Imaging devices" + +config USB_MDC800 + tristate "USB Mustek MDC800 Digital Camera support" + ---help--- + Say Y here if you want to connect this type of still camera to + your computer's USB port. This driver can be used with gphoto 0.4.3 + and higher (look at ). + To use it create a device node with "mknod /dev/mustek c 180 32" and + configure it in your software. + + To compile this driver as a module, choose M here: the + module will be called mdc800. + +config USB_MICROTEK + tristate "Microtek X6USB scanner support" + depends on SCSI + help + Say Y here if you want support for the Microtek X6USB and + possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. + Support for anything but the X6 is experimental. + Please report failures and successes. + The scanner will appear as a scsi generic device to the rest + of the system. Scsi support is required. + This driver can be compiled as a module, called microtek. -- cgit v1.3.1