From c3e4c9a25c2910d2d66d52215b3406b13d5b23d5 Mon Sep 17 00:00:00 2001 From: Yuval Adam Date: Sun, 29 Jun 2014 12:34:32 +0300 Subject: Add more board models --- boards/dk-tm4c129x/ble_btool/readme.txt | 45 +++++++++++++++++++++++++++++++++ 1 file changed, 45 insertions(+) create mode 100644 boards/dk-tm4c129x/ble_btool/readme.txt (limited to 'boards/dk-tm4c129x/ble_btool/readme.txt') diff --git a/boards/dk-tm4c129x/ble_btool/readme.txt b/boards/dk-tm4c129x/ble_btool/readme.txt new file mode 100644 index 0000000..c19917d --- /dev/null +++ b/boards/dk-tm4c129x/ble_btool/readme.txt @@ -0,0 +1,45 @@ +Bluetooth Low Energy ``BTool'' + +This application connects the ICDI virtual UART0 with UART3, so that +the BTool application running on PC can control the CC2540/CC2541 through +the TM4C129X. + +The CC254X device should be programmed with HostTestRelease(Network +Processor) application. A hex file containing this application can be +found in the BLE stack 1.4.0 release under +C:\\...\\BLE-CC254x-1.4.0\\Accessories\\HexFiles\\ +CC254X_SmartRF_HostTestRelease_All.hex. Please refer to the Bluetooth Low +Energy CC254X Development Kit User's Guide for information on how to load +the hex file to the CC254X. This User's Guide can be found in +http://www.ti.com/lit/ug/swru301a/swru301a.pdf + +On the TM4C129X development board, make sure that jumpers PJ0 and PJ1 +are connected to the "EM_UART" side to ensure that the UART3 TX and RX +signals are routed to the EM header. UART3 is used to communicate between +the TM4C129X and the CC2540 device. + +BTool is a PC application that allows a user to form a connection between +two BLE devices. For more details on BTool, please refer to the above +User's Guide. The installer for BTool is included in the BLE stack 1.4.0 +release under C:\\...\\BLE-CC254x-1.4.0\\Accessories\\BTool\\ + + +------------------------------------------------------------------------------- + +Copyright (c) 2013-2014 Texas Instruments Incorporated. All rights reserved. +Software License Agreement + +Texas Instruments (TI) is supplying this software for use solely and +exclusively on TI's microcontroller products. The software is owned by +TI and/or its suppliers, and is protected under applicable copyright +laws. You may not combine this software with "viral" open-source +software in order to form a larger program. + +THIS SOFTWARE IS PROVIDED "AS IS" AND WITH ALL FAULTS. +NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT +NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR +A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. TI SHALL NOT, UNDER ANY +CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL +DAMAGES, FOR ANY REASON WHATSOEVER. + +This is part of revision 2.1.0.12573 of the DK-TM4C129X Firmware Package. -- cgit v1.3.1