rtl-sdr/src/tuner_r820t.c, branch masterMirror repo for various hacks on rtl-sdrhttps://git.yuv.al/rtl-sdr/atom/src/tuner_r820t.c?h=master2013-01-16T00:43:45Zlib: enable standby mode of e4k and r820t on exit2013-01-16T00:43:45ZSteve Markgrafsteve@steve-m.de2013-01-16T00:43:45Zurn:sha1:84f0a9084bb944c0cd36289a462978054e93ca35
Since the R820T is a power hog and gets quite hot,
this makes sense, especially when being battery-
powered.
Signed-off-by: Steve Markgraf <steve@steve-m.de>tuner_r820t: check if Nint is within allowed range2012-10-26T17:22:52ZSteve Markgrafsteve@steve-m.de2012-10-26T17:22:52Zurn:sha1:c179f860d5f8fed418be1fc4fc33d5ec2b504d0a
Signed-off-by: Steve Markgraf <steve@steve-m.de>tuner_r820t: add manual RF gain setting2012-10-18T23:17:28ZSteve Markgrafsteve@steve-m.de2012-10-18T23:17:28Zurn:sha1:25789493c678f20bb8b58c7f60e06e96bf314c18
Signed-off-by: Steve Markgraf <steve@steve-m.de>tuner_r820t: improve tuning accuracy, allow freq correction2012-10-07T00:32:14ZSteve Markgrafsteve@steve-m.de2012-10-07T00:32:14Zurn:sha1:d64c969bd6d9e56aa1424cbe719efce562120ee0
We now use Hz instead of KHz for calculating the PLL
parameters, and use the actual crystal frequency in Hz,
which allows to correct the frequency error in ppm.
Signed-off-by: Steve Markgraf <steve@steve-m.de>tuner_r820t: don't perform IMR calibration on init2012-09-09T15:45:00ZSteve Markgrafsteve@steve-m.de2012-09-09T15:45:00Zurn:sha1:0c3c356d19ce39655dc9f94c94d68d2ab16d2152
This takes simply too much time (almost 3 seconds)
and doesn't really seem to make any difference for our
use case.
Signed-off-by: Steve Markgraf <steve@steve-m.de>add initial support for the R820T tuner2012-09-08T00:37:30ZSteve Markgrafsteve@steve-m.de2012-09-08T00:37:30Zurn:sha1:5a26bd51e77f54160854d668c590a2d1d53265a5
Signed-off-by: Steve Markgraf <steve@steve-m.de>